
Serving Nixa, Springfield and surrounding Counties in SW Missouri
The below Services are offered on a FLAT RATE, not an hourly one. Paid and done.
Home and yard Cleaning and Upgrades
Trash haul off! FLAT RATE CHARGES!
|
Brush, Log, wood, Bush and Yard Waste Haul Off!
|
Clean Outs! Storage, sheds, barns and more!
- Be Sold - Be recycled (once materials have been removed, they can not be retrieved, once they have reached their final destination.) |
GENERAL HAUL OFFS
GAS is FIGURED into the FLAT RATE in the END. |
General Hauling!
|
Distance Can Add Gas charges to this project!PICKING up your old Stove, or other appliance, that can be delivered to the appliance recycle center- is $50 - additional units $25.
|
ATTIC LADDER INSTALL:
$300 + Materials ($200+) = $500 Installed, cut in and Trimmed. You can have ease of access to your attic space. Material Price for most basic unit/ install. Variance in price would include
|
Power wash Home "Siding"
- Using resistance Soap - Slows film growth - Seals Vinyl Pores $50 per Side 1 story. An entire home can take a person about 4-10 hours to get every inch cleared of debris. Hours of holding a rattling Sabre is more hard work than one would think even in heat. |
Sidewalk & Stone Porch Decks
- $100 per 100 sq feet 10 x10 - This is time consuming as the mildew always runs deep. For sidewalk and yard patio stone and brick cleaning, we take ground measurements and do the math. In example: Sidewalk Measurement of 3 foot wide - would be about 33.33 feet of sidewalk to be cleaned. Approx 11 = 3 x 3 tiles. |
Power washing is hot, messy work. My clothes I wear are utterly useless- so imagine each visit I am likely going to lose a set of clothes that can not be recovered in a washing machine. It is messy, but the end result is worth it for sure~
Mold/ Growth is mainly on the North side of surfaces, and is always a good navigation identifier.
|
Do you have a grimy Wood or vinyl fence?
If your wood fence was built with treated wood, it is likely a good cleaning will bring the wood back to NEW. The key here is if the pores of the wood were able to be clogged with the connecting matter of molds and fungus.
If the wood was treated when it was built, (meaning the boards under pressure, not untreated boards coated in a fake magic sealant) through pressure treatment- than it is likely this growth will come right off using my special MIXTURE that is all natural and not a danger to you, your pets, yard or gardens. This same MIX is what i use on siding as well and it leave a clean sheen on the surface preventing future growth from developing as quickly. Three sides at 40 feet, takes about 10 hours of work in the sun, coated in debris flying from your surfaces. Water pools soak your feet and yard, and on occasion you will throw water and mud at yourself- but it is rewarding work. |
TIE DOWNS for Outbuildings:
$40 a Pin! Suggested Pins:
This is required for SHEDS and OUTBUILDINGS in some counties DON'T get a FINE! Call me! Auditors will let you know the HARD way. This is not only for your protection, but that of your neighbors as well! |
MOVE YOUR SHED!Flat rate fee for Short distance Shed moving. Basically I will come with a CREW and move your shed up to 50 feet from its present position for $300.00
Sometimes, you realize - this Shed would be better over there, let us solve this problem! Restrictions may apply
|
Shed Leveling! get back to square! Call for a leveling!
Simple Leveling = $50.00 (Takes 30 min to an hour) Complex Leveling/ Lifting (Takes 2-5 hours) $150-$250.00 Simple is what folks need most. |
" Did you know, that a Shed or Outbuilding should not be 100% square and level? Yes. There should be 1/8 inch pitch forward toward the Door, to keep water from running inside your building. And the Door should be on the side facing away from storms and wind patterns." - RJOT
Shed Removal/ Tare Downs
ALL WOOD SHED REMOVAL
(All Wood Structures)
"Building tare down pricing- varies by size, and if it has a loft or not. Pricing covers weight prices at the dump by the ton, and 4 hours labor for (up to) 3 workers (including myself) It is dangerous, which is why I oversee the project and do the deconstructing, we are self insured so no worries of me or my workers coming after you for our mistakes. I have been doing this awhile now, so when it comes to building decon(struction) - i don't make mistakes. If we can get close to your building or not also factors into the price. If we have to carry and haul everything to the trailer, it takes longer and costs more. Barn styles cost more. Labor is not free, and skill is worth more ( we have both),
thank you have a blessed day." - Stephen (RJOT) Owner, Operator.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
It is about ease of access, tonnage and labor. (Pricing)
Basic Idea on pricing: (see metal shed pricing below)
{See Added variables below, which adds to the cost, based on 1)Shed Access 2) Finished Interior 3) 1 or 2 Story Structure.)
8 x 8 = $250
8 x 10,12 = $350
10 x 10,12 + = $450
12 x 20 + = $550
Larger = $650 Multiple loads and trips. Add Dump runs + fuel (Average $350 a Load x amount of loads)
(Basically $175 a ton, includes gas, haul off, and labor on large buildings)
Four added variables:
- Loft or 2 story Height (Sheds only) + $100
- Access to the building with my trailer (no access? Carrying it all?) , if we are carrying debris across the yard it adds time, and cleanup Add $150
- Finished Interior, (Sheet Rock/ Power lines/ insulation?), if the building is finished on the inside, it adds $100-$150 on 8x buildings, and $200+ on 10x buildings, and $250 for 12x and greater.
EXAMPLE:
" Weight from sheet rock. Turns an 8 x 12 into 3.5 tons, not fun at the scales." When it is normally a Ton unfinished.
*Due to embarrassment, and confusion on all parties at the last tare down, I will be requiring pictures of your shed and your gate and yard. So there is no misunderstandings, complicated access, I will come and check the situation out before giving a bid.
(All Wood Structures)
"Building tare down pricing- varies by size, and if it has a loft or not. Pricing covers weight prices at the dump by the ton, and 4 hours labor for (up to) 3 workers (including myself) It is dangerous, which is why I oversee the project and do the deconstructing, we are self insured so no worries of me or my workers coming after you for our mistakes. I have been doing this awhile now, so when it comes to building decon(struction) - i don't make mistakes. If we can get close to your building or not also factors into the price. If we have to carry and haul everything to the trailer, it takes longer and costs more. Barn styles cost more. Labor is not free, and skill is worth more ( we have both),
thank you have a blessed day." - Stephen (RJOT) Owner, Operator.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
It is about ease of access, tonnage and labor. (Pricing)
Basic Idea on pricing: (see metal shed pricing below)
{See Added variables below, which adds to the cost, based on 1)Shed Access 2) Finished Interior 3) 1 or 2 Story Structure.)
8 x 8 = $250
8 x 10,12 = $350
10 x 10,12 + = $450
12 x 20 + = $550
Larger = $650 Multiple loads and trips. Add Dump runs + fuel (Average $350 a Load x amount of loads)
(Basically $175 a ton, includes gas, haul off, and labor on large buildings)
Four added variables:
- Loft or 2 story Height (Sheds only) + $100
- Access to the building with my trailer (no access? Carrying it all?) , if we are carrying debris across the yard it adds time, and cleanup Add $150
- Finished Interior, (Sheet Rock/ Power lines/ insulation?), if the building is finished on the inside, it adds $100-$150 on 8x buildings, and $200+ on 10x buildings, and $250 for 12x and greater.
EXAMPLE:
" Weight from sheet rock. Turns an 8 x 12 into 3.5 tons, not fun at the scales." When it is normally a Ton unfinished.
*Due to embarrassment, and confusion on all parties at the last tare down, I will be requiring pictures of your shed and your gate and yard. So there is no misunderstandings, complicated access, I will come and check the situation out before giving a bid.
Metal Sheds/ Buildings: Wood vs Cement Pads.
METAL SHED REMOVAL
(No Wood Beams or Floor)
This includes Labor, Time, Gas and Haul off costs. |
METAL SHED REMOVAL
(Wood Floors or Supports)
This includes Labor, Time, Gas and Haul off costs. |
Concert level sound and Quality for HIRE!
WE ARE NOT RESPONSIBLE for POLICE CALLS:
Real Jack of Trades Has Connections! Are you throwing a HUGE EVENT or want a PARTY with sound the likes of GOD has not heard in a Backyard or Pool House? Call us!
|
" In a constant battle against the elements and their forces over our human structures in Hot/ Humid climates; a Handyman's #1 weapon is the Wood screw."
Get NEW VINYL SIDING!
Standard Pricing on materials for a one story home is about $2500.00. Assembled in 5 days. My labor price $2000.00 (one story home 40 foot) |
Coming Soon! Drone Surveys.
10 minutes of approx footage on Video & image combination -- $200.00 |
Coming Soon! Drone Photo/ Video footage by request.
Images & Clips (20) $100.00 Video 10 minute clips $200.00 |
We are independently insured and will NOT pursue property owners if hurt on the job. However, our services are layman grade, repairs, upgrades and upkeep, and we do not have insurance coverage for damages to home, land or property. We approach all with caution, and do not accept work that may put the property owners in economic or legal jeopardy. Consider us friends that have come to help you on a task you can not do yourself. We are not Certified Contractors & do not do certified work on properties and follow all Town, City, County, State & Federal laws..